Water To Oil Cooler - Installation

WATER-TO-OIL COOLER





1. Guide the oil cooler onto the studs located on the cylinder block.
2. Install the upper (2) and lower nuts to cylinder block finger tight.
3. Install and tighten mounting bolt (1) to cooler at cylinder block to 24 N.m (18 ft. lbs).
4. Torque the nuts to 24 Nm (18 ft. lbs.)
5. Install the ground cable. Install the retaining nut (6).
6. Tighten lower mounting bolt to cooler at the cylinder block. Tighten to 77 Nm (57 ft. lbs.).

NOTE: Use a back-up wrench on the transmission cooler fittings to prevent damage to the cooler.

7. Tighten upper mounting bolt to cooler at cylinder block to 24 N.m (18 ft. lbs).
8. Install wire harness push in clip at bottom of cooler bracket.
9. Install starter motor Starter - Installation.
10. Connect battery negative cables.
11. Fill cooling system Service and Repair.
12. Check transmission oil level and fill as necessary.