Cylinder Head Cover

CYLINDER HEAD COVER





1. Remove the bolts (1) and the engine cover.
2. Disconnect both negative battery cables.






NOTE: Pneumatic tools should NOT be used to remove or install the cover.

3. Remove the oil fill cap.
4. Remove the breather cover capscrews.
5. Remove the Close Crankcase Ventilation (CCV) cover (4) and breather filter.
6. Disconnect the CCV Tube (1) at the Crankcase Depression Regular (CDR) valve.
7. Disconnect the crankcase pressure sensor connector (2).
8. Remove the CCV oil drains (3) from cylinder head cover (2 hoses).
9. Remove the cylinder head cover capscrews.
10. Remove the cylinder head cover.





11. Disconnect both injector harness connectors.
12. Remove the injector wire nuts (1) from the valve cover gasket.
13. Remove the cylinder head cover gasket (2).