Vibration Damper - Installation

INSTALLATION

Non-High Output Engine





NOTE: The damper must be installed so the hole is located over the dowel pin.

1. Install the crankshaft damper and bolts. Tighten bolts to 40 Nm (30 ft. lbs.) plus an additional 60° in a criss-cross pattern.
2. Install the accessory drive belt Serpentine Accessory Drive Belt - Installation.

High Output Engine





NOTE: Ensure that the friction shim is installed, and that the damper is installed so the hole is located over the dowel pin (2).

1. Install the friction shim (5) vibration damper (4). Tighten bolts (1) to 40 Nm (30 ft. lbs.) plus an additional 60° in a criss-cross pattern.
2. Install the accessory drive belt Serpentine Accessory Drive Belt - Installation.