Hood Release Cable - Installation

INSTALLATION





1. Position the handle (1) and align the clips to the instrument panel feature location.
2. Press handle to seat the clips to the instrument panel.





3. Route the latch end of hood latch release cable tube through the dash panel and into the engine compartment. Feed the entire length of the cable through the dash panel.
4. Press the grommet (1) into the hole in the dash panel by hand until fully seated.
5. Route the cable along the fender rail and to the outboard and front of the vertical support post and seat the mounting clips (2) fully.





6. Route cable (3) through the front end module and on to the latch (5).
7. Align and insert end of cable (1) to the mechanism on the latch (5).
8. Press the collar (2) into the hole and snap into place.
9. Seat the mounting clips (4) fully.