Rear

REAR










1. Install the caliper (6) to the caliper adapter (1).
2. Coat the caliper mounting slide pin bolts (3) with silicone grease and install. For Cab Chassis tighten to 30 Nm (22 ft. lbs.). For 4500, 5500 series tighten to 133 Nm (98 ft. lbs.).

CAUTION: Verify that the brake hose is not twisted or kinked before tightening the fitting bolt.

3. Install the brake hose banjo bolt if removed.
4. Install the brake hose (4) to the caliper (6) with new seal washers and tighten fitting bolt to 27 Nm (245 in. lbs.).

5. Remove the prop rod from the brake pedal.
6. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.Service and Repair.
7. Install the wheel and tire assemblies Service and Repair.
8. Remove the supports and lower the vehicle.
9. Verify a firm pedal before moving the vehicle.