Electric Locking Differential Carrier Bearings - Removal

REMOVAL





1. Remove the differential case from the housing.
2. Install Plug 8888 (1) into the end of the differential case on the coil side.
3. Install Puller 6444 (2) onto the end of the plug (1).





4. Install puller Jaws 9915 (1) onto puller (2) and around the bearing.





5. Install puller collar (1) onto puller jaws (2). Tighten puller bolt and remove bearing. NOTE: Bearing on the other side of the case can be removed with Puller C-293-PA and Adapters 9614.