B163F

B163F-FRONT RIGHT TURN CONTROL CIRCUIT LOW







- When Monitored:
With the Turn Signal activated.

- Set Condition:
When the Totally Integrated Power Module (TIPM) detects a low condition.





1. INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all TIPM DTCs.
3. Turn the Right Turn Signals on.
4. With the scan tool, read the DTCs.

Does the scan tool display DTC B163F-FRONT RIGHT TURN CONTROL CIRCUIT LOW?

Yes

- Go To 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. (L60) RIGHT FRONT TURN LAMP DRIVER CIRCUIT




1. Turn the ignition off.
2. Disconnect the TIPM C5 harness connector.
3. Disconnect the Right Front Park/Turn Lamp harness connector.
4. Measure the resistance between ground and the (L60) Right Front Turn Lamp Driver circuit.

Is the resistance below 5.0 Ohms?

Yes

- Repair the short to ground in the (L60) Right Front Turn Lamp Driver circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the TIPM.
- Perform the BODY VERIFICATION TEST. Body Verification Test.