Engine Mount: Adjustments

1. Remove the load on the engine motor mounts by carefully supporting the engine and transmission assembly with a floor jack.
2. Loosen the right engine mount insulator vertical fastener and the fore and aft fasteners, and the front engine mount bracket to front crossmember screws.
3. Pry the engine right or left as required to achieve the proper drive shaft assembly length.
4. Tighten engine mounts and fasteners in the following order:
a. Right engine mount insulator vertical bolts to 102 Nm (75 ft. lbs.) and the fore and aft bolts to 150 Nm (110 ft. lbs.).
b. Front engine mount screws to 54 Nm (40 ft. lbs.) the clearance between the snubbers and the engine should be 2 mm (0.078 inch) each side.
c. Left engine mount through bolt to 75 Nm (55 ft. lbs.).
5. Recheck driveshaft length.