Seat Belt: Service and Repair

Front Seat Uni-Belt:

Front Seat Uni-Belts:

Center Lap Belts:

Seat Belt Mounting Folding Rear Seat:

Jump Seat Belts:

UNI-BELTS - FRONT SEATS
The uni-belts are mounted to the "B" pillar as shown. The buckle half is located on the inboard side of the seat, mounted to the underbody. The "B" pillar half of the belt is secured with bolts torqued to 350 inch pounds +\- 150 inch pounds (40 Nm +\- 17 Nm).

SAFETY BELTS - REAR SEAT
The rear folding seat is available with the outboard buckles mounted to the underbody and inboard retractors mounted on the seat frame rear cross member. The center buckle tip half is mounted to the latch mechanism. Torque the belt bolts to 350 inch pounds +\- 150 inch pounds (40 Nm +\- 17 Nm).

SEAT BELTS AND RETRACTORS
For assembly and views refer to figures above. The center belt mountings are typical. Be sure when belts or retractors are replaced that the bolts are tightened to 350 in. lbs. +\- 150 in. lbs. (40 Nm +\- 17 Nm) for safety requirements.