Front Cable Replacement

Fig 1 Parking Brake Cable Routing (Part 1 Of 2):

Fig 1 Parking Brake Cable Routing (Part 2 Of 2):

REMOVAL
1. Remove adjusting nut at adjusting link.
2. Disengage cable housing at lower anchor point and remove cable and housing from bracket.
3. Remove cable housing retaining clip at parking brake lever.
4. Remove retaining clip from lever.
5. Remove end of cable from clevis.
6. Remove housing grommet from floor pan.


INSTALLATION
1. Insert cable and housing through floor pan and install housing grommet.
2. Install retainer clip at upper end of cable housing and engage cable end in slot of lever clevis.
3. Engage cable housing at lower anchor bracket and install clip.
4. Connect cable at adjusting link by installing adjusting nut.
5. Adjust service brakes and parking brake cable.
6. Apply brakes several times and test for free wheel rotation when parking brake is in the "off" position.