Rear Door Glass Run

Removal Procedure




1. Remove the rear door glass.
2. Remove the interior garnish molding.
3. Remove the screws and the exterior garnish molding.




4. Remove the glass run.

Installation Procedure




1. Install the glass run.






NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.

2. Install the exterior garnish molding with the screws.

Tighten
Tighten the rear door exterior garnish molding screws to 1.5 Nm (13 lb.in).

3. Install the interior garnish molding.
4. Install the rear door glass.