Removal and Installation

Removal Procedure
1. Disconnect the negative battery cable.





2. Remove the bolt and disconnect the hose from the clutch release cylinder.





3. Remove the clutch release cylinder bolts and remove the release cylinder from the transaxle.

Installation Procedure





1. Connect the release cylinder to the transaxle and install the bolts.
Tighten
Tighten the release cylinder bolts to 60 Nm (44 ft. lbs.).





2. Connect the hose assembly to the cylinder body.
3. Apply grease where the pushrod connects to the release lever. Be careful not to stain the boot.
4. Bleed the air. Refer to Clutch, M/T; Service and Repair; Air Bleeding.
5. Adjust the clutch pedal. Refer to Clutch Pedal Assembly; Adjustments.
6. Fill the reservoir with clutch/brake fluid up to the MAX level.
7. Connect the negative battery cable.