EGR Valve: Service and Repair

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Disconnect the exhaust gas recirculation (EGR) valve electrical connector.
3. Remove the EGR valve retaining bolts.
4. Remove the EGR valve from the electronic ignition (EI) system ignition coil adapter.

INSTALLATION PROCEDURE




1. Clean the EI system ignition coil adapter mating surface.
2. Install a new EGR valve gasket.
3. Install the EGR valve with the bolts.

Tighten
Tighten the exhaust gas recirculation valve retaining bolts to 20 Nm (15 lb-ft).

4. Connect the EGR valve electrical connector.
5. Connect the negative battery cable.