Interior Courtesy Lamp/Power Sunroof Control Switch

Removal Procedure
1. Disconnect the negative battery cable.
2. Pry off the lamp lens.
3. Remove the screws and the lamp/power sunroof control switch.
4. Disconnect the electrical connector.

Installation Procedure

1. Connect the electrical connector.

NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.

2. Install the lamp/power sunroof control switch with the screws.

Tighten
Tighten the lamp/power sunroof control switch screws to 4 Nm (35 lb.in).

3. Install the lamp lens.
4. Connect the negative battery cable.