Disassembly and Reassembly

Disassembly Procedure
1. Remove the crossmember assembly from the vehicle.





2. Remove the stabilizer clamp bolts. Remove the stabilizer clamps, the stabilizer bar, and the insulators.





3. Remove the control arm front nuts and the bolts.





4. Remove the split sleeves from the control arm rear connections.
5. Remove the control arms.





6. Remove the crossmember link-to-crossmember bolt.
7. Remove the crossmember link.

Assembly Procedure
1. Install the crossmember link.





2. Install the crossmember link-to-crossmember bolt.
Tighten
Tighten the crossmember link-to-crossmember bolt to 114 Nm (84 ft. lbs.).





3. Install the control arms.
4. Install the split sleeves into the control arm rear connections.
5. Install the control arm-to-crossmember nuts and the bolts.
Tighten
Tighten the control arm-to-crossmember nuts to 110 Nm (81 ft. lbs.).





6. Install the stabilizer clamps, the stabilizer bar, and the insulators.
7. Install the stabilizer shaft-to-crossmember clamp bolts.
Tighten
Tighten the stabilizer shaft-to-crossmember clamp bolts to 22 Nm (16 ft. lbs.).
8. Install the crossmember assembly from the vehicle.