Windshield Washer Pump - Installation

INSTALLATION

NOTE: The washer pump/motor unit may be removed from the washer reservoir without removing the reservoir from the vehicle.





1. Lubricate a new rubber grommet seal with clean washer fluid and install it into the washer pump mounting hole in the washer reservoir (4). Always use a new rubber grommet seal on the reservoir.
2. Position the inlet nipple at the base of the pump housing of the washer pump/motor unit (7) to the rubber grommet seal in the reservoir.
3. Using hand pressure, press firmly and evenly on the washer pump/motor unit until the inlet nipple is fully seated in the rubber grommet seal in the pump mounting hole of the reservoir.
4. Reconnect the washer hose (2) to the barbed outlet nipple of the washer pump.
5. Reconnect the headlamp and dash wire harness (1) connector for the washer pump/motor unit (5) to the connector receptacle on the top of the pump motor.
6. Reinstall the fasteners that secure the right front wheel house splash shield to the inner fender panel and the front fascia. Splash Shield - Installation.
7. Lower the vehicle.
8. Reconnect the battery negative cable.
9. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.