Washer Fluid Level Switch - Installation

INSTALLATION

NOTE: The washer fluid level switch may be removed from the washer reservoir without removing the reservoir from the vehicle.





1. Lubricate a new rubber grommet seal with clean washer fluid and install it into the washer fluid level switch mounting hole in the washer reservoir (4). Always use a new rubber grommet seal on the reservoir.
2. Position the barbed nipple of the of the washer fluid level switch (3) to the rubber grommet seal in the reservoir.
3. Using hand pressure, press firmly and evenly on the washer fluid level switch until the barbed nipple is fully seated in the rubber grommet seal in the switch mounting hole of the reservoir.
4. Reconnect the washer hose (2) to the barbed outlet nipple of the washer pump.
5. Reconnect the headlamp and dash wire harness (1) connector for the washer fluid level switch (6) to the connector receptacle for the switch.
6. Reinstall the fasteners that secure the right front wheel house splash shield to the inner fender panel and the front fascia. Splash Shield - Installation.
7. Lower the vehicle.
8. Reconnect the battery negative cable.
9. Refill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.