Front Door Glass - Removal

REMOVAL





1. Remove the trim panel from the inside of the front door, Front Door Trim Panel - Removal.
2. Remove the inner belt weatherstrip from the front door.
3. Open the latch access panel located on the carrier plate near the lock rod assembly.
4. Remove the clear adhesive patch covering the front window regulator access hole located just behind the electronic door module. If the clear adhesive patch is not present, there will be an indented area in the same location that will need to be cut out.
5. Temporarily install the window switch pod, reconnect the negative battery cable and lower the window (1) until the white regulator tabs are visible in both access holes.
6. With the help of an assistant holding the glass, release the window regulator tab and lift the window up and tape the glass (1) to the door header.
7. Remove the door carrier plate, Front Door Carrier Plate - Removal.
8. With the help of an assistant holding the glass, remove the tape and lower the glass (1) into the carrier plate cavity.
9. Remove the glass (1) through the carrier plate cavity.