Rear Suspension Compression Link - Installation

INSTALLATION






NOTE: Although the compression link is different end-to-end, there is no top and bottom.

1. Position link and install bolt and nut (1) mounting link (3) at crossmember. Do not tighten bolt at this time.
2. Install bolt and nut (2) mounting link (3) at knuckle. Do not tighten bolt at this time.





3. Install tire and wheel assembly (1) Tires And Wheels - Installation
4. Lower vehicle.
5. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access link fasteners.
6. Tighten compression link fasteners to:
- Bolt at crossmember - 85 Nm (63 ft. lbs.).
- Bolt at knuckle - 81 Nm (60 ft. lbs.).

7. Perform wheel alignment Wheel Alignment Procedures.