Fuel Injector - Installation

3.6L





1. Lightly lubricate the new O-ring seals (1) with clean engine oil and position the seals onto the fuel injector (2).






NOTE: Number 2 fuel injector installation shown, all other fuel injectors similar.

2. Install the fuel injectors (1) into the fuel rail (2).





3. Install the fuel rail and upper intake manifold Fuel Rail - Installation.





4. Position the air inlet hose assembly (5) onto the throttle body and the air cleaner housing.
5. Secure the air inlet hose assembly retaining grommet onto the ball stud (4).
6. Tighten the clamp at the air cleaner housing (3) to 5 Nm (44 in. lbs.).
7. Tighten the clamp (2) at the throttle body to 5 Nm (44 in. lbs.).
8. Connect the Inlet Air Temperature (IAT) sensor electrical connector (1).





9. Lift the engine cover retaining grommets off the ball studs and remove the engine cover (1).





10. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
11. Start the engine and check for leaks.