Installation

INSTALLATION





1. Install the rubber isolators into the vapor canister mounts.
2. Position the vapor canister, ESIM, and fresh air filter into the vehicle as an assembly.





3. Slide the vapor canister rubber isolators onto the mounting bracket.
4. Raise the front of the vapor canister onto the mounting stud.
5. Install the vapor canister retaining nut (1) and tighten to 9 Nm (80 in. lbs.).





6. Connect the vapor purge line (3) quick-connect fitting to the EVAP canister.
7. Connect the fuel tank vapor line (2) quick-connect fitting to the EVAP canister.
8. Connect the ESIM electrical connector (1).





9. Install the right rear wheelhouse splash shield.
10. Install the right rear tire.
11. Lower the vehicle.
12. Install the fuel tank filler cap.
13. Connect the negative battery cable (1).
14. Start the engine and check for leaks.