Pressure Hose

ALL-WHEEL-DRIVE





1. Install pressure hose in engine compartment from underneath.

NOTE: Always use a NEW O-ring on the end of the pressure or return hose at the gear.

2. Lubricate NEW O-ring on steering gear end of pressure hose with clean power steering fluid.
3. Insert pressure hose into steering gear (2) port and install tube nut (3). Do not tighten tube nut at this time.





4. Route pressure hose along left side of engine cradle. Install screw through routing clamp and secure hose to left side of engine cradle.
5. Route pressure hose along front of engine cradle. Install screw through routing clamp (1) and secure hose to front of engine cradle (2).






NOTE: Always use a new O-ring on the end of the pressure line.

6. Lubricate the new O-ring on the end of the pressure line with clean power steering fluid.
7. Install power steering pressure line to EHPS Pump (3).
8. Install pressure line retaining bolt (2) and tighten to 10 Nm (89 in. lbs.).





9. Tighten pressure (3) hose tube nut at steering gear (2) to 47 Nm (35 ft. lbs.).
10. Fill and bleed power steering system Service and Repair.
11. Install right front wheel house splash shield.
12. Lower vehicle.





13. Connect battery negative cable (2) to battery post. It is important that this is performed properly.