Vanity Lamp - Removal

REMOVAL






NOTE: Vehicles equipped with optional vanity lamps have a single lamp at each side of the covered mirror that is integral to each sun visor. Each lamp is independently controlled by an integral switch that is automatically actuated by the mirror cover. The lamp housings, the switch, the mirror and the mirror cover are serviced only as a unit with the sun visor. The bulb types and service procedures are identical for each of these lamp bulbs.

1. Disconnect and isolate the battery negative cable.
2. Insert a small flat-bladed screwdriver on either side near the top or the bottom between the vanity lamp lens (2) and the lamp housing of the sun visor (1).
3. Carefully pry the lens outward until it unsnaps from the lamp housing.





4. Using small needle-nose pliers, carefully grasp the bulb (2) and pull the base out of the lamp socket.