Trunk Lamp - Installation

LAMP





1. Position the trunk lamp to the mounting hole (1) in the right or left trunk side trim panel.
2. Reconnect the body wire harness connector (2) to the connector receptacle (3) integral to the lamp housing.
3. Insert the connector end of the lamp into the lower end of the mounting hole in the trunk side trim panel far enough to engage the fixed retention tabs with the edge of the mounting hole.
4. Using hand pressure, press the upper (notched) edge of the lamp lens (4) into the mounting hole until the movable retention tabs snap into place and the lens is just proud of the trim panel.
5. Reconnect the battery negative cable.