Rear

BULB - REAR






NOTE: The rear dome/reading lamps are integral to the grab handle (1) in the headliner on the inner roof side rail over each outboard rear seating position. The lamp housing, switch and wiring are serviced only as a unit with the grab handle assembly.

1. Disconnect and isolate the battery negative cable.
2. Using a small thin-bladed screwdriver, gently pry the forward end of the reading lamp lens (2) away from the grab handle far enough to unsnap it from the lamp housing.
3. Pull the front end of the lens outward far enough to disengage the larger rear lens tab from the lamp housing.





4. Pull the base of the bulb (1) straight forward out of the bulb holders (2) within the lamp housing.