Clock - Removal

REMOVAL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Disconnect and isolate the negative battery cable.
2. Remove the instrument panel center bezel, Instrument Panel Center Bezel - Removal.
3. Remove the three screws (3) that secure the clock (1) to the back of the center bezel.
4. Remove the clock from the center bezel.