Humidity Sensor - Removal

REMOVAL





1. Disconnect and isolate the negative battery cable

CAUTION: Use care when removing the humidity sensor cover. The humidity sensor bracket cannot be serviced separately from the windshield. If the sensor bracket becomes damaged, the windshield will need to be replaced.

2. Carefully disengage the four retaining tabs (2 and 4) that secure the cover (3) to the humidity sensor bracket (1) by pressing in on the right side of the cover, while rocking the left side of the cover off the bracket.






CAUTION: Use care when removing the humidity sensor. The humidity sensor bracket cannot be serviced separately from the windshield. If the sensor bracket becomes damaged, the windshield will need to be replaced.

3. Using a small screwdriver or similar tool, carefully disengage the metal retaining clip (3) from the sensor bracket (2) and remove the humidity sensor (4) and the clip as an assembly.
4. Disconnect the wire harness connector (1) from the humidity sensor.
5. If the humidity sensor bracket is damaged and cannot be reused, replace the windshield Windshield - Removal.