Brake Master Cylinder - Assembly

ASSEMBLY





1. Install NEW brake fluid reservoir sealing grommets (2) in master cylinder housing (1).





2. Lubricate reservoir mounting area with fresh clean brake fluid. Place reservoir in position over sealing grommets. Seat reservoir into sealing grommets using a rocking motion while firmly pressing down on fluid reservoir. Once installed, make sure fluid reservoir is touching the top of both sealing grommets (2) or reservoir is not properly installed.
3. Install fluid reservoir mounting screw (3). Tighten screw to 28 Nm (250 in. lbs.).

4. Thoroughly bleed master cylinder before installing it on vehicle. Procedures




5. Install master cylinder on power brake booster. Upon installation, vacuum seal (1) on rear of master cylinder must be replaced. Brake Master Cylinder - Installation