Sunroof Motor - Installation

INSTALLATION

SINGLE PANE SUNROOF

WARNING: Do not attempt to move or reposition the sunroof glass panel or drive cables with the sunroof motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.

WARNING: The Sunroof Motor And Module Initialization procedure must be completed any time a sunroof motor and module unit is replaced with a new component. Failure to perform this procedure may result in damage to the vehicle, to the sunroof or in serious or fatal injuries. Programming and Relearning .





1. Position the sunroof motor and module unit (4) close enough to the headliner bracket (5) for the overhead console to access and reconnect the overhead wire harness connector to the motor and module connector receptacle (3).
2. Position the motor and module through the headliner bracket opening and onto the sunroof frame.
3. Install and tighten the three screws (2) that secure the motor and module to the sunroof frame. Tighten the screws to 4 Nm (35 in. lbs.).
4. Reinstall the overhead console onto the headliner (1). Overhead Console - Installation.
5. Reconnect the battery negative cable.
6. Perform the Sunroof Motor And Module Initialization procedure. Programming and Relearning.

DUAL PANE SUNROOF OR SUNSHADE

WARNING: Do not attempt to move or reposition the sunroof glass panel, the sunshade or the drive cables with the sunroof or sunshade motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.

WARNING: The Sunroof Panel Calibration procedure and the Sunroof Motor And Module Initialization procedure must be completed any time a sunroof or sunshade motor and module unit is replaced with a new component. Failure to perform these procedures may result in damage to the vehicle, to the sunroof, to the sunshade or in serious or fatal injuries. Programming and Relearning .





1. Position the sunroof or sunshade motor and module unit (4) to the sunroof frame.
2. Install and tighten the three screws (2) that secure the motor and module unit to the sunroof frame. Tighten the screws to 3.8 Nm (34 in. lbs.).
3. Reconnect the sunroof wire harness connector (3) to the motor and module unit connector receptacle.
4. Reinstall the headliner to the inner roof panel (1). Headliner - Installation.
5. Reconnect the battery negative cable.
6. If a previously initialized sunroof or sunshade motor and module unit has been reinstalled, perform the Dual Pane Sunroof Or Sunshade Override Position Calibration procedure. Programming and Relearning.
7. If a new sunroof or sunshade motor and module unit has been installed, perform the Sunroof Motor And Module Initialization procedure. Programming and Relearning.