Instrument Panel Bin - Installation

INSTALLATION





1. Connect the LED/Lamp wiring harness (2) to the rear of the storage bin (1).
2. Connect the 12V power outlet wiring harness to the rear of the storage bin (1).
3. Align the storage bin (1) to the front floor console and the side close out panel to engage the two snap retainers and alignment pins that secure the storage bin (1) to the floor console.
4. Install the two screws (3) securing the storage bin (1) to the front console. Tighten the screws to 2 Nm (18 in. lbs.).





5. Connect the shifter bezel wiring harness and position the console shifter bezel (1) over the gear selector lever.
6. Position the tabs on the underside of the console shifter bezel (1) into the holes in the floor console. Use hand pressure to engage the retaining tabs.
7. Install and tighten the two screws (1) that secure the front of the console shifter bezel to the console. Tighten the screws to 3 Nm (23 in. lbs.).
8. Position the mat (5) into the console rear bin with the curved edge oriented forward in the vehicle.
9. Slide the retaining ring over the shifter shaft (2) and slide the shifter knob (3) onto the shaft and push down into place until fully locked.
10. Reconnect the negative battery cable.