Front Carpet - Installation

FRONT






NOTE: The front carpet consists of two individual carpets, one for the driver side and one for the passenger side. These carpets can be removed from and installed into the vehicle individually.

1. Position and fit the front carpet (3) onto the floor panel. Be certain that the rear of the front carpet is fitted over the floor panel front crossmember and butts up against the front of the rear carpet without interference with the rear floor air duct opening. Be certain that the front of the front carpet is fitted to the dash panel without interference with the steering column, the accelerator or the heater and air conditioner unit. On the driver side only, be certain the slit (4) on the inboard edge of the carpet is engaged around the left instrument panel support bracket (5) on the top of the floor panel transmission tunnel.
2. Install the two push-pin fasteners (1) that secure the outboard edge of the front carpet to the front door opening sill.
3. On the driver side only, install the push-pin fastener (2) that secures the front carpet to the cowl side inner panel above the foot rest.





4. On the driver side only, install the push-pin fastener (3) that secures the inboard edge of the front carpet (1) to the transmission shifter bracket (2).
5. Reinstall the trim onto the driver or passenger side lower cowl side inner panel as appropriate. Cowl Trim Panel - Installation.
6. Reinstall the center console onto the front floor panel transmission tunnel. Floor Console - Installation.
7. Reinstall the driver and/or passenger front seat into the vehicle as appropriate. Front Seat - Installation.