Underbody Shield - Installation

INSTALLATION






NOTE: Right side shown, left side typical.

1. Position the underbody shield (1) to the vehicle.
2. Install the sixteen retaining nuts (3) that secure the underbody shield (1) to the vehicle underbody. Tighten the nuts securely.
3. Install the five fasteners (4) located near the front of the shield that secure the underbody shield (2) to the vehicle.
4. Install the two fasteners (1) that secure the underbody shield (1) to the rear wheelhouse splash shield.





5. Install the three fasteners (1) that secure the underbody shield (2) to the front wheelhouse splash shield. Tighten the fasteners securely.
6. Lower the vehicle.