Gas Prop - Installation

INSTALLATION






NOTE: LH shown, RH typical.

1. Position the ball socket on the cylinder end of the support cylinder (1) to the ball stud on the upper bracket of the deck lid hinge.
2. Using hand pressure, press the ball socket onto the ball stud until the retainer clip snaps into place.
3. Position the ball socket on the rod end of the support cylinder to the ball stud on the lower bracket of the deck lid hinge.
4. Using hand pressure, press the ball socket onto the ball stud until the retainer clip snaps into place.
5. Inspect to be certain that the retaining clip on each of the support cylinder ball socket ends is fully seated.
6. Remove the service prop or block and close the deck lid.