Intrusion Module Sensor - Installation

INSTALLATION

Second Row Intrusion Sensor

The second row intrusion sensor is in the snap plate of the second row lamp assembly. Intrusion Module - Installation.

Third Row Intrusion Sensor

1. Install the intrusion sensor into the dome lamp assembly.
2. Connect the intrusion sensor.
3. Install the third row dome lamp.
4. Connect the negative battery cable.

Sensor Harness

1. Lower the headliner to gain access to the sensor harness which is glued to the top of the headliner. Headliner - Removal
2. Overlay the new harness near the old one and secure it with tape.
3. Cut off the old connectors but leave the old harness. It is safer to leave it because removing it may damage the headliner.
4. Raise the headliner as necessary to install and connect the sensors.
5. Finish installing the headliner. Headliner - Installation.