Alarm System Transponder: Testing and Inspection

FOBIK PROGRAMMING

The Radio Frequency Hub (RF-Hub) may be programmed to recognize up to a total of eight FOBIKs. When replacing or adding a FOBIK, the integrated key must be cut to match the door lock cylinder in the vehicle for which it will be used. Once an additional or new key has been cut, the RF-Hub must be programmed to recognize it as a valid FOBIK. When programming a FOBIK it may be necessary to have the vehicle PIN. Follow the instructions on the scan tool screen.

Programming

NOTE: All FOBIKS that are to be used in this vehicle must remain on the front seat near the center console but behind the shifter.

NOTE: Do not put a Laptop or any wireless device (cell phone, audio device, etc.) on top of or near the center console. The RF Antenna is below the console.

1. Turn the ignition on.
2. With the scan tool select RFH.
3. Turn the ignition to the off/lock position. The ignition must be left off throughout this procedure on vehicles equipped with the RF-Hub.
4. With the scan tool select; "Misc. Functions" "Program Ignition FOBIKs".

NOTE: When programming a FOBIK, hold it near or on the center console top.

NOTE: When you are instructed to "Press the Unlock button" it is important that you do not hold the button. Press it One time quickly.

5. Press "Continue" and follow the instructions on the screen.