Installation

INSTALLATION





1. Lubricate the two rubber mount sockets (2) on the resonator (1) with Mopar(R) Rubber Bushing Installation Lube.
2. Install the resonator to the throttle body inlet. Push the resonator (1) down onto the two locating pins (3) on the right cylinder head cover until the rubber mount sockets (2) are fully seated.





3. Install the push pin (3).
4. Install the air inlet hose to the resonator (1) and tighten the clamp (4) to 4 Nm (35 in. lbs.).
5. Connect the electrical connector (2) to the Inlet Air Temperature (IAT) sensor.





6. Install engine cover (1).
7. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).