Engine Oil Cooler - Installation

INSTALLATION






NOTE: Always use new dry seals (1) when installing the oil cooler. Do not lubricate the seals.

1. Install the new oil cooler seals (1) onto the oil filter housing (2).





2. Position the oil cooler (4) on the oil filter housing.
3. Install two screws (1) and (3). Tighten the screws to 4 Nm (35 in. lbs.).
4. Install four bolts (2) and tighten to 12 Nm (106 in. lbs.).
5. Install the upper and lower intake manifolds and air cleaner housing assembly Intake Manifold - Installation
6. Fill the engine crankcase with the proper oil to the correct level Service and Repair
7. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
8. Fill the cooling system Service and Repair.
9. Operate the engine until it reaches normal operating temperature. Check cooling system for correct fluid level Service and Repair