Power Steering Hose - Installation

INSTALLATION





1. Install the power steering return hose (7) into the engine compartment.
2. Install the return hose routing clamp screw (1) securing the return hose (7) to the body.
3. Raise and support the vehicle. Maintenance
4. Install the return hose routing clamp screw (6) securing the return hose (7) to the frame rail. Tighten the screw to 8 Nm (71 in. lbs.).
5. Install the screws (3) securing the return hose to the frame rail (2). Tighten the screws to 8 Nm (71 in. lbs.).
6. Install the return hose onto the cooler line (4) and install the hose clamps (5).





7. Install the return hose (1) at the return tube (2) and install the clamp. If a screw-clamp is used, tighten it to 2.5 Nm (20 in. lbs.).

8. Install the lower fascia valance.
9. If equipped, install the belly pan below the engine.
10. Lower the vehicle.
11. Install the coolant recovery bottle. Coolant Recovery Bottle - Installation
12. Install the power steering fluid reservoir. Reservoir, Power Steering Pump - Installation
13. Fill and bleed the power steering system. Service and Repair
14. Check for leaks.