Totally Integrated Power Module (TIPM) - Installation

INSTALLATION





1. Position the TIPM into the engine compartment.
2. Connect the harness connectors to the bottom of the TIPM.
3. Install the B+ cable (2) to the TIPM stud (3).
4. Install the TIPM B+ cable retainer (1).Tighten the nut to 9 Nm (80 in. lbs.).





5. Flip the TIPM to the upright position.
6. Position the TIPM onto the mounting bracket and push down until the mounting clips are fully seated.
7. Fully seat the airbag fuse holder (two fuses in one yellow carrier) and the Ignition Off Draw (IOD) fuse.
8. Connect the negative battery cable.
9. Insert the ignition key and turn it to the "RUN" position and wait twelve seconds. The TIPM will collect the necessary vehicle configuration and VIN data from the CCN and PCM at this time. After twelve seconds turn the ignition key to the "OFF" position and then back to the "ON" position and verify proper vehicle systems operation.