Tail Stop Turn Lamp Bulb - Removal

BULB

Each rear lamp unit for both the Chrysler and Dodge versions of this vehicle includes a single incandescent bulb for the Reverse (or backup) lamp function and multiple Light-Emitting Diode (LED) units for the park (or tail) lamps, the brake (or stop) lamps, rear side marker lamps and turn signal lamps. The incandescent bulb is available for individual service replacement; however, if an LED unit is ineffective or damaged, the entire rear lamp unit must be replaced.




Figure 1 - Chrysler



Figure 2 - Dodge
1. Disconnect and isolate battery negative cable.
2. Remove the rear lamp unit (1) from the vehicle. . Tail Stop Turn Lamp - Removal
3. Firmly grasp the bulb socket (2) on the back of the rear lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out of the lamp.
5. Pull the base of the bulb straight out of the socket.