Power Brake Booster - Removal - RHD
RIGHT-HAND-DRIVE - 2.0L/2.4L GAS ENGINE
NOTE: Before proceeding, Warning Brakes - Caution .
CAUTION: The vacuum in the power brake booster must be pumped down before removing the master cylinder to prevent the booster from sucking in any contamination. This can be done by pumping the brake pedal while the engine is not running until a firm brake pedal is achieved.
1. With the engine not running, pump the brake pedal 4-5 strokes until the pedal feel is firm.
2. Disconnect the negative (ground) cable from the battery and isolate the cable.
3. Remove the engine appearance cover.
4. Using a refrigerant recovery machine, remove the refrigerant from the air conditioning system.
5. Remove the nut (1) securing the cam sensor heat shield (2) in place on the rear of the engine cylinder head. Remove the heat shield.
6. Remove the stud securing the engine lift bracket (4) to the rear of the engine cylinder head. Remove the bracket.
7. Disconnect the wiring connector (3) at the cam sensor and move it down out of the way.
8. Remove the upper and loosen the two lower fasteners (1) securing the heat shield (3) to the studs (2) located on the dash panel. Remove the heat shield.
9. Remove the fasteners securing the coolant recovery bottle to its mounts and move it away from the power steering fluid reservoir and air conditioning liquid and suction line assembly. It is not necessary to disconnect the coolant recovery bottle fluid lines Coolant Recovery Bottle - Removal.
10. Remove the fastener securing the power steering fluid reservoir to its mount and move it away from the air conditioning liquid and suction line assembly. It is not necessary to disconnect the power steering fluid lines Reservoir, Power Steering Pump - Removal.
11. Remove the booster vacuum hose routing clip (4) from the master cylinder mounting stud.
12. Remove the vacuum hose routing clip (3) from the stud on the dash panel.
13. Remove the nut (1) securing the air conditioning line retaining bracket (2) to the right strut tower (5).
14. Remove the bolt (3) that secures the air conditioning liquid and suction line assembly (4) to the air conditioning evaporator (6).
15. Disconnect the air conditioning liquid and suction line assembly from the air conditioning evaporator and remove and discard the dual-plane seals.
16. Install plugs in, or tape over the open refrigerant line fittings and the evaporator ports.
17. Move air conditioning liquid and suction line assembly away from the power brake booster. Use care not to bend lines.
18. Remove the master cylinder Brake Master Cylinder - Removal.
19. Disconnect the vacuum hose (2) from the check valve (1) on the power brake booster. Do not remove the check valve from the power brake booster.
20. Remove both brake tube routing clips with tubes from the studs on the dash panel. Do not bend the brake tubes.
21. Remove the steering column opening cover on the instrument panel Steering Column Opening Cover - Removal.
22. Remove the stop lamp switch Stop Lamp Switch - Removal.
23. Remove the retaining clip (1) securing the power brake booster push rod (2) to the brake pedal. To do so, position a small screwdriver under the center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3). Remove and discard the clip. Do not reuse the clip.
24. Slide the booster push rod (2) off the brake pedal pin (3).
25. Remove the four nuts (4) attaching the power brake booster (1) to the dash panel.
26. Slide the power brake booster (3) forward clearing the dash panel, then move it inboard of the brake tubes. At the same time, rotate it so the push rod on the rear of the booster is facing upward, then move it slowly across the rear of the engine compartment above the exhaust manifold. Remove the booster through the opening where the air cleaner housing is normally mounted.