Seat Cushion Pan - Installation

INSTALLATION






NOTE: Power seat shown, manual seat fastening locations similar.

NOTE: If replacing the power or manual seat adjuster, remove the track stops from the front of both tracks. These stops need to be removed to snap into the same track locations on the new seat adjuster. If a stop is damaged, a new one should be ordered and installed.

1. Set the seat cushion pan into place on the seat frame.
2. Install the wire harness to the seat pan.
3. Connect the heated seat connector, if equipped.
4. Install the seat pan cushion fasteners (1). Tighten to 11 Nm (8 ft.lbs.).
5. Install the seat back.Front Seat Back Recliner - Installation
6. Install the seat into the vehicle.Seat - Installation