Front Bumper Fascia - Removal

REMOVAL





1. Open the hood.
2. Disconnect the negative battery cable.
3. Raise and support the vehicle.
4. Remove the front splash shield, Splash Shield - Removal.
5. Remove the fascia lower closeout panel, Front Lower Fascia Closeout - Removal.
6. If equipped, disconnect the fog lamps.
7. Remove the fender to fascia fastener (2). Repeat for the opposite side.
8. Lower the vehicle slightly.
9. On Avenger models, remove the front outboard push pin fastener (1).





10. On Sebring models, remove the front outboard fastener (1).






NOTE: Avenger shown, Sebring similar.

11. Remove the four fascia to upper radiator support push pins (1).
12. Pull out on the fascia sides to disengage the fascia retaining tabs.
13. Remove the fascia from the vehicle.