Rear

REMOVAL

1. Disconnect the negative battery cable.
2. Raise and support the vehicle.




3. Remove the 12 belly pan fasteners (1) and remove the belly pan (2).

4. Remove the right front half shaft Half Shaft - Removal.
5. Remove the retainer nuts at the extension pipe.
6. Remove the retainer from the bracket to bell housing.
7. Remove the center crossmember Crossmember - Removal.
8. Remove the exhaust maniverter cross under pipe Exhaust Cross under Pipe - Removal.
9. Remove the front extension pipe.
10. Disconnect and remove rear maniverter lower oxygen sensor.
11. Remove the lower heat shield retainers.
12. Remove the upper heat shield nuts.
13. Disconnect and remove the rear maniverter upper oxygen sensor and heat shields.
14. Remove the rear maniverter retaining bolts the rear maniverter.