Driver Door Fails To Unlock

DRIVER DOOR FAILS TO UNLOCK





For a complete wiring diagram, refer to the Wiring Information .






NOTE: This test does not cover a Secondary Latch problem on a right hand drive vehicle.
(P238) DRIVER DOOR UNLOCK DRIVER WIRE SHORT TO GROUND




1. Turn the ignition off.
2. Disconnect the Instrument Cluster C1 connector.
3. Measure the resistance between ground and the (P238) Driver Door Unlock Driver circuit.

Is the resistance below 1,000 ohms?

Yes

- Repair the (P238) Driver Door Unlock Driver wire for a short to ground.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Instrument Cluster.
- Perform the BODY VERIFICATION TEST. Body Verification Test.