Front Window Moves About 3 Inches And Quits

FRONT WINDOW MOVES ABOUT 3 INCHES AND QUITS






NOTE: The Driver circuits are shown but the Passenger side is similar.

For a complete wiring diagram, refer to the Wiring Information .






1. TEST FOR DIAGNOSTIC TROUBLE CODES
1. Turn the ignition on.
2. With the scan tool, read the DTCs.

Does the scan tool display any Power Window related DTCs?

No

- Go To 2

Yes

- Diagnose and repair the DTC(S).
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. WINDOW HALL SENSOR A AND SENSOR B SIGNAL CIRCUIT OPEN
1. Disconnect the appropriate Door Module C2 connector.
2. Disconnect the appropriate Window Motor connector.
3. Measure the resistance of the Window Hall Sensor A Signal circuit between the Motor connector and the Module C2 connector.
4. Measure the resistance of the Window Hall Sensor B Signal circuit between the Motor connector and the Module C2 connector.

Is the resistance below 2.0 ohms on both Signal circuits?

No

- Repair the Window Hall Sensor Signal circuit(s) for opens.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

Yes

- Replace the Window Motor.
- Perform the BODY VERIFICATION TEST. Body Verification Test.