U0027

U0027-CAN B BUS (-) SHORTED TO BUS (+)







- When Monitored:
Continuously.

- Set Condition:
The Totally Integrated Power Module (TIPM) detects the (D55) CAN B Bus (+) circuit is shorted to the (D54) CAN B Bus (-) circuit.





1. TEST FOR INTERMITTENT CONDITION

NOTE: Check for any Technical Service Bulletins (TSBs) related to the condition. If a TSB applies, perform the procedure outlined in the TSB before continuing.

1. Turn the ignition on.
2. Using the scan tool, record and erase TIPM DTCs.
3. Cycle the ignition from on to off three times.
4. Turn the ignition on.
5. Using the scan tool, read active TIPM DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.

2. CHECK THE (D55) CAN B BUS (+) CIRCUIT FOR A SHORT TO THE (D54) CAN B BUS (-) CIRCUIT




1. Turn the ignition off.
2. Disconnect the Totally Integrated Power Module C3 harness connector.
3. Measure the resistance between the (D55) CAN B Bus (+) circuit and (D54) CAN B Bus (-) circuit.

Is resistance below 1000.0 Ohms?

Yes

- Go To 3

No

- Inspect the wiring and connectors for damage or shorted circuits. If ok, replace the Totally Integrated Power Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

3. (D55) CAN B BUS (+) CIRCUIT SHORTED TO THE (D54) CAN B BUS (-) CIRCUIT




1. Measure the resistance between the (D55) CAN B Bus (+) circuit and (D54) CAN B Bus (-) circuit.
2. While monitoring the ohmmeter, disconnect each CAN B Bus module one at a time.

NOTE: This is to determine if the circuits are shorted together internally within a module or if the circuits are shorted together in the harness.

NOTE: Disconnecting an in-line connector can eliminate a module or group of modules from the list of possible causes for this fault. Refer to the wiring diagrams to assist in diagnosis.

Is resistance below 1000.0 Ohms with all the CAN B Bus modules disconnected?

Yes

- Repair the (D55) CAN B Bus (+) circuit for a short to the (D54) CAN B Bus (-) circuit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the module, that when disconnected eliminated the shorted together circuits.
- Perform the appropriate verification test for the module being replaced. If there is no verification test for the associated module perform the BODY VERIFICATION TEST. Body Verification Test.