Wireless Control Module (WCM)

B2205-ORIGINAL VIN MISSING/MISMATCH



- When Monitored:
At ignition on, after ignition on during any rolling code handshake that occurs with the Powertrain Control Module (PCM) due to a Sentry Key remote Entry Module (SKREEM) also known as the Wireless Control Module (WCM) or PCM reset.

- Set Condition:
A valid key is recognized but the programmed VIN does not match between the WCM and PCM/ECM.





1. DETERMINING IF DIAGNOSTIC TROUBLE CODE (DTC) IS CURRENT
1. With the scan tool, erase the WCM DTCs.
2. Turn the ignition off.
3. Wait 10 seconds.
4. Turn the ignition on and wait 2 minutes.
5. With the scan tool, read the WCM DTCs.

Does the scan tool display the DTC that was previously erased?

Yes

- Go To 2

No

- Go To 4

2. VERIFYING THE PCM VIN
1. Turn the ignition on.
2. With the scan tool, select Engine system from the main menu.
3. Display and record the Vehicle Identification Number.

NOTE: Ensure that a VIN has been programmed into the PCM. If a VIN is not displayed, attempt to program the PCM with the correct VIN before continuing.

Does the VIN recorded from the PCM match the VIN of the vehicle?

Yes

- Go To 3

No

- Replace and program the Wireless Control Module.
- Perform the WCM VERIFICATION TEST. Wireless Control Module (WCM) Verification Test

3. REPLACE WCM AND CHECK DTC'S
1. Turn the ignition off.
2. Replace and program the Sentry Key Remote Entry Module.
3. Turn the ignition on.
4. With the scan tool, display and clear all PCM and WCM DTCs.
5. Perform 5 ignition key cycles leaving the ignition key on for 90 seconds per cycle.
6. With the scan tool, check for WCM DTCs.

Does the scan tool display the same DTC?

Yes

- Replace and program the Powertrain Control Module.
- Perform the WCM VERIFICATION TEST. Wireless Control Module (WCM) Verification Test

No

- The repair is complete.
- Perform the WCM VERIFICATION TEST. Wireless Control Module (WCM) Verification Test

4. INTERMITTENT
1. Turn the ignition off.

NOTE: Check for the following conditions:
- Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires.
- Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
- Search for any Technical Service Bulletins (TSB) that may apply.

Were any problems found?

Yes

- Repair wiring harness/connectors as necessary.
- Perform the WCM VERIFICATION TEST. Wireless Control Module (WCM) Verification Test

No

- Test Complete.