B165C

B165C-PARK LAMP CONTROL CIRCUIT LOW







- When Monitored:
With the Parklamps activated.

- Set Condition:
When the TIPM detects a low condition.





1. INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all TIPM DTCs.
3. Turn the Park Lamps on.
4. With the scan tool read the DTC information.

Does the scan tool read: B165C-PARK LAMP CONTROL CIRCUIT LOW?

Yes

- Go To 2

No

- The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. (L217) PARK LAMP CONTROL CIRCUIT SHORT TO GROUND




1. Turn the ignition off.
2. Disconnect the TIPM C3 harness connector.
3. Disconnect the Left and Right Park Lamp harness connectors.
4. Measure the resistance between ground and the (L217) Park Lamp Control circuit.

Is the resistance below 5.0 Ohms?

Yes

- Repair the (L217) Park Lamp Control circuit for a short to ground condition.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Totally Integrated Power Module (TIPM).
- Perform the BODY VERIFICATION TEST. Body Verification Test.