Front Seat Back Handle And Cable - Installation

INSTALLATION





1. Make sure the shoulder belt (3) is positioned correctly in the mounting bracket.
2. Position the handle cable (1) down through the mounting bracket (2) and push down through the seat back assembly.





3. Position the rear of the handle assembly (1) over the mounting bracket and seat the front of the handle (2) fully.





4. Position the handle bezel (1) over the handle assembly and seat the bezel fully.





5. Connect the rear entry release cable to the release latch (2) and the mounting bracket (1).





6. Install the lower inner shield (2) and fasteners (1).





7. Secure the seat back cover (1) J-clips.
8. Install the lower outer shield (2).